Body parts

Cover for dishwasher front panel. Sticker on backside, lenght 522 mm, height 40 mm.

Commercial dishwasher green signal light R693055. Attachment hole diameter 12mm. 230V. Fits for Fagor -models manufactured before year 2008.

Commercial dishwasher orange signal light Z203079000. Attactment hole diameter 9mm. Lens outer diameter 10mm. 6,3 mm Abiko-connectors. 230V. Fits for Fagor -models manufactured after year 2008.

Commercial dishwasher water boiler heating element O-ring seal. Inner diameter 47 mm, outer diameter 57 mm. Thichness 5,34 mm. Replaces part 0L2765. Fits for many Electrolux EUC, NUC -series models & for heating elements 049980, 0L1851, 058666, 0C5336.

Commercial dishwasher 50/60 Hz vibrating detergent dispenser GRI 230V. Fits for Metos WD-series professional dishwashers.

Professional dishwasher rinse aid pump Mod. CM 620120 IDRAULICO.

Professional dishwasher door spring, fits Metos Master 2 and Metos Master 3.

180° water valve for commercial dishwasher / appliance. Input 1/2" male thread, output 1/2" male thread (outer diameter of the thread approx. 20 mm). 230V ac 50 / 60Hz. Maximum water temperature 90 °C.

Forssan Huoltopalvelu Ltd does not take any responsibility for accidents occurring in the installation of products or damage caused by incorrectly installed products. The installation of any electronic spare part has to be installed by a professional person with electrical permits required by law professional.  If an electronic component is installed by a person without electrician degree or needed permits the customer is responsible for any possible accidents / damage.

The center of the bottom washing arm of a commercial dishwasher. Grey plastic. Threads for nut. Fits many Colged ISYTECH, NEOTECH, PROTECH, STARTECH, STEELTECH, TOPTECH, Elettrobar RIVER series models. Check the fit table for your model.

Commercial dishwasher door spring for the side door. 25 x 0.5 mm. Made of spring steel. Makes it easier to open the inspection / service door on the side of the tunnel dishwasher. Fits many Electrolux Zanussi models. Check the fit table for your model.

• Width 25 mm
• Outer diameter 44 mm
• Inner diameter 32 mm
• 53N

Professional dishwasher tank connector, thread 12 mm, hose connectors 4 and 7 mm.

Thermal protection of the water heating boiler of a commercial dishwasher. To be reseted from the button. Cut-off temperature 110 degrees. 6.3 mm Abiko flat connectors. 16A 250V 50/60Hz. Replaces part Elettrobar 236039. Suitable for e.g. for many Colged, Elettrobar models.

Forssan Huoltopalvelu Ltd does not take any responsibility for accidents occurring in the installation of products or damage caused by incorrectly installed products. The installation of any electronic spare part has to be installed by a professional person with electrical permits required by law professional.  If an electronic component is installed by a person without electrician degree or needed permits the customer is responsible for any possible accidents / damage. Electronic spare parts have no right of return if they have been tested in place on the device.

Overheating protection for the boiler of commercial dishwashers. Imit 21/21C STB 90-110°C Type LS1 6025. Suitable for many professional dishwashers.

• Adjustable cut-off temperature +90... +110°C.
• Sensor size 6.5 x 80 mm
• Capillary tube length 1000 mm
• Manual reset button under the plastic protective cap
• 16A 250V ac
• 6.3 mm Abiko flat connectors
• The distance between the mounting holes is 28 mm

Bottom strainer / sieve filter for a large household dishwasher. Grey plastic. This part has a thread that keeps the bottom well of the machine against the bottom of the washing room. Original spare part for many Electrolux Professional and Zanussi hood type dishwashers, e.g. EHT8, NHT8, ZHT8.

The bottom strainer / tank filter cup located at the bottom of the washing compartment of a commercial dishwasher. Grey plastic. Original spare part for many Electrolux Professional, Zanussi, Alpeninox AHT8, EHT8, NHT8, ZHT8 series cup dishwashers. Check the suitability for your model in the suitability table with the model information of the machine.

• Height 100 mm
• Diameter 165 mm

Commercial pull-through dishwasher door spring for Meiko models K200 ja K400. Check door width; there are two of these in 50 cm door and four in 120 cm door.

For 80 cm door, you need spring 7.1A (11421).

• Plate length 50 mm
• Total length 920 mm
• Width 40 mm

Hood type commercial dishwasher basket support, original spare part. See list for compatible models.

Commercial dishwasher door spring, original spare part. See list for compatible models.

Commercial dishwasher door flat spring support roll, spring surrounds this part. Original spare part.

Commercial dishwasher thermometer, original spare part. There are usually two of these in a dishwasher. See list for compatible models. 

• Range 0-120°C
• Mounting hole 44,5 x 44,5 mm
• Frame 48 x 48 mm
• Bulb ø 6 x 36 mm
• Capillary 2900 mm

Dishwasher button thermostat / over heating protection. cut-off temperature 105°C. Reset button, manual reset. Replaces the previous 100°C version 103347. Power rating 16A 250V AC.

Forssan Huoltopalvelu Ltd does not take any responsibility for accidents occurring in the installation of products or damage caused by incorrectly installed products. The installation of any electronic spare part has to be installed by a professional person with electrical permits required by law professional.  If an electronic component is installed by a person without electrician degree or needed permits the customer is responsible for any possible accidents / damage. Electronic spare parts have no right of return if they have been tested in place on the device.

Rocker switch with rubber protection and green light. An excellent switch for dirty and damp locations where high current resistance is required. Protected by a rubber cover. Black frame. The remaining positions are ON-OFF. Suitable for many coffee machines, dishwashers, other large household appliances, industrial machines and other electrical appliances.

Commercial dishwasher door seal 22 x 9,5 mm, length 1050 mm. Fits model Metos Master 3.

Shaft seal of the washing pump / circulating water pump wing of a commercial dishwasher. Suitable for a pump with a 13 mm shaft. Includes sealing ring and sliding ring. Replaces 0141003, L351667, 141003, RAT210, 500593, RX94804366, H33839, 0145R+0142R, 5017792. Suitable for several LGB pump types, like ZF800DX, ZF650DX. Suitable for e.g. for the pumps of many COLGED, Comenda, Elettrobar large household dishwashers. Check the fit for your model in the fit table.

Commercial dishwasher presuure chamber, original spare part for EHT8- and NHT8- hood type machines etc. See list for compatible models.