Display / control panel located in the refrigerator door. Circuit board, tactile buttons. Pressed on the door, the change is carried out using a suction cup. Original spare part for a few models of the LG GL5241 (GC-B401, GR-B401) series. Check the fit for your model in the fit table.
In cabinets where the control panel/display is located in the door, the cause of the fault is more often a break in the wiring between the panel and the device's main circuit board than the panel itself. The wiring harness runs through the door's upper hinge and as it wears out, it starts to break at the hinge. It is necessary to measure whether all the wires are intact before the fault can be localized to the panel. The panel must be removed so that the wires can be measured ohmically. If necessary, contact your local home appliance service/electrician to perform the measurement. Sometimes it also happens that if the wiring harness breaks at the hinge, it causes a short circuit in the panel/display card and the display card also suffers. In this case, you must first repair the wiring harness and then replace it with a new display card (a faulty wiring harness will probably break the new card as well).
Forssan Huoltopalvelu Ltd does not take any responsibility for accidents occurring in the installation of products or damage caused by incorrectly installed products. The installation of any electronic spare part has to be installed by a professional person with electrical permits required by law professional. If an electronic component is installed by a person without electrician degree or needed permits the customer is responsible for any possible accidents / damage. Electronic spare parts have no right of return if they have been tested in place on the device.
