Aertecnica_putkiston_osat

Central vacuum cleaner wall inlet installation disc.

Wall inlet spacer. Raise the wall inlets 20mm. To be glued from the wall inlet end. PVC-plastic.

Pipeline gentle corner piece for connecting two 2" (50,8mm) straight pipes. To be glued from both ends. PVC-plastic.

Pipe extension corner 45°. To be glued from both ends. PVC-plastic.

Pipe extender for connecting two 2" (50,8mm) straight pipes. To be glued from both ends. PVC-plastic.

Pipe Y-connection. To be glued from all ends. PVC-plastic.

Pipe T-connection. To be glued from all ends. PVC-plastic.

Pipeline end plug. The plug closes the open pipe. PVC-plastic.

Pipeline collar. PVC-plastic

Piping output wind shield. Brown plastic. This flap opens when vecuum cleaner starts and closes immediatly when cleaner is turned off. Blocks wind, cold air & moisture from getting into the pipeline. Fits directly to Aertecnica 2" (50,8mm) piping.

Fast-acting adhesive for gluing PVC pipes together. Suitable for gluing parts of central vacuum cleaner piping.

A very fast-acting adhesive that connects PVC pipes to create durable and airtight joints. A handy applicator is attached to the lid for applying the adhesive. Make sure that the ends to be glued are clean and that there are no plastic burrs where the pipe may have been cut. The pipes will bond immediately, so match the pipes first and immediately place the pipes to be glued at the right angle.

One can is enough to glue three boxes and 22 meters of piping. Made in the USA.

PVC pipe for installing a central vacuum cleaner. 220 cm straight pipe. The outer diameter of the pipe is 50.8 mm (2"). Suitable for e.g. Beam and Aertecnica vacuum cleaners. This piping system is intended for adhesive joints.